danger if frothing milk is forced out.
Caution: z e lid with insert must be
tted during operation.
Caution: z e milk container heats up
during operation. Do not touch hot
surfaces.
Hold the container only by its handle.
e appliance may only be used with the z
original accessory parts provided by the
manufacturer.
e appliance must always be set on a rm, z
level surface.
Do not allow the appliance or its power z
cord to come into contact with open
ames or any hot surfaces such as hot-
plates.
Do not allow the power cord to hang free; z
the cord must be kept well away from hot
parts of the appliance.
Always remove the plug from the wall z
socket
in case of any malfunction, -
a er use, -
to turn the appliance o completely, -
before cleaning the appliance. -
When removing the plug from the wall z
socket, never pull on the power cord;
always grip the plug itself.
No responsibility is accepted if damage z
results from improper use, or if these
instructions are not complied with.
is appliance is intended for domestic or z
similar applications, such as in
sta kitchens, o ces and other -
commercial environments,
agricultural areas, -
hotels, motels etc. and similar -
establishments,
bed-and-breakfast guest houses. -
In order to comply with safety regulations z
and to avoid hazards, repairs of electrical
appliances must be carried out by quali ed
personnel, including the replacement
of the power cord. If repairs are needed,
please send the appliance to one of our
customer service departments. e
address can be found in the appendix to
this manual.
Before using for the rst time
Remove any packaging materials and check
that all components are present.
Before the appliance is used for the rst
time, or a er extended periods of non-use, it
should be thoroughly cleaned as described in
the section General Care and Cleaning.
Operation
We recommend the use of long-life low-fat
milk (UTF, 1.5% fat content). For best results,
the milk should be taken from the refrigerator
immediately before frothing.
e underside of the container and the contact
area on the inside of the base must be clean
and dry.
Choosing the stirring head
Use the smooth stirring head to heat up –
milk.
For frothing and heating milk at the same
–
time, use the serrated head.
For cold-frothing milk, also use the –
serrated head.
When not in use, the stirring heads may be –
safely stored at the rear of the housing.
Fill amounts
Always observe the minimum mark and –
ensure the container is lled with at least
100 ml milk.
For frothing, ll the container to a –
maximum of 350 ml (lower max mark
).
For heating, ll the container to a –
maximum of 700 ml (upper max mark
).
Heating up or frothing milk
1. Place the container onto the base.
2. Remove the lid from the milk
container.
3. Place the appropriate head onto the
mounting protrusion inside the bottom
of the container.
4. Put the required amount of milk into
the container.
9
(42 páginas)
(10 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais